Harbor Freight Tools 90692 operating instructions Figure D, To Assemble The Tool Holder

SQUARE NUT (47)

SUPPORT BAR (54)

SQUARE						FLAT WASHER
NUT
						(40)
(47)
				LOCKWASHER
	(34)
		FLAT WASHER (40)				HANDLE
						(48)
			LOCKWASHER (34)
					HANDLE (48)

FIGURE D

To Assemble The Tool Holder:

1.Loosen the two Set Screws (20) on the Tool Holder (24), and extend the Cutting Tool (31) out about 4 inches. Then re-tighten the two Set Screws to secure the Cutting Tool in place. (See Figure E.)

2.Slide the Pattern Follower Assembly into the T-Slot located at the bottom of the Tool Holder (24). (See Figure E.)

SET SCREW (20)

TOOL HOLDER (24) . .

CUTTING TOOL (31)

T-SLOT

PATTERN FOLLOWER

ASSEMBLY

FIGURE E

SKU 90692 PAGE 8