To Attach The Tool Holder Assembly:
1.Slide the Cutting Tool (31) of the Tool Holder (24) into the Slot located on the Side Plate (50). (See Figures E and F.)
2.Attach the Spring (19) over the Pointer (14) on the Side Plate (50).
(See Figure F.)
3.Adjust the Spring (19) so that there is enough tension to keep the Tool Holder (24) firmly against the Support Bar (54). (See Figure F.)
SUPPORT BAR (54)
|
|
|
| POINTER (14) | ||||
|
|
|
|
|
|
|
| |
|
| TOOL |
|
|
| SPRING | ||
SLIDE PLATE | HOLDER |
|
|
| ||||
(19) | ||||||||
(50) | (24) | |||||||
|
|
|
| |||||
FIGURE F
To Attach The Safety Shield:
1.Attach the Safety Shield Bracket (10) to the Safety Shield (8), using the Pan Head Screw (9), Flat Washer (21), and Hex Nut (7).
(See Figure G, next page.)
2.Unscrew and remove the Handle (51) from the Bolt located on the Support Bar (54). Place the Safety Shield Plate (43) on the Bolt. Then,
(See Figure G.)
3.Attach the Safety Shield Bracket (10) to the Safety Shield Plate (43), using a Hex Head Bolt (11), Flat Washer (40), and Hex Nut (39).
(See Figure G.)
SKU 90692 | PAGE 9 |