Grizzly G1067Z instruction manual Tool Rest Tailstock

Tool Rest Tailstock

The tool rest is equipped with a cam-action clamping system to secure it to the lathe bed. When the lever is thrown, a locking plate lifts up and secures the tool rest to the bed. To install the tool rest assembly:

1.Remove the large Hex Nut and lock plate from the bottom of the tool rest assembly.

2.Set the tool rest assembly on the lathe bed with the clamp stud between the bed slot.

3.Set the tool rest lock handle so it is pointing down. Re-install the lock plate and thread the Hex Nut back onto the stud until it bot- toms out.

4.Lift the lock handle approximately 90˚ and tighten the Hex Nut 1⁄2 to 2⁄3 of a turn more.

5.Turn the tool rest lock handle until it locks the tool rest down onto the bed. You may need to adjust the Hex Nut in small increments to fine tune how the tool rest assembly locks down onto the bed.

Figure 7.

Thread the handle onto the tailstock handwheel and tighten down the jamnut. Figure 8.

Figure 8.

-10- G1067Z Wood Lathe