Clean up |
| Site Considerations |
|
|
|
|
|
|
The bed and other unpainted parts of the Model G1067Z are coated with a waxy oil that protects them from corrosion during shipment. Remove the protective coating with mineral spirits and paper towels. DO NOT use gasoline or other petroleum based solvents because of their extremely low flash points. Serious personal injury may occur. DO NOT use
Follow the safety rules listed below when working with solvents. Failure to do so may result in serious personal injury.
1.Read and follow all directions and warnings on the solvent label.
2.Work only in a well ventilated area.
3.Do not work near any type of open flame (e.g., pilot lights, kerosene heaters, and so on).
4.DO NOT smoke while working with flammable material.
5.Paper towels from the cleaning process are extremely combustible. Dispose of waste towels so they do not create a fire hazard.
Floor Load: Your G1067Z Lathe represents a large weight load in a small footprint. Most commercial floors are suitable for the Model G1067Z. Some residential floors may require additional build up to support both machine and operator.
Working Clearances: Consider existing and anticipated needs, size of material to be processed through each machine, and space for auxiliary stands, work tables or other machinery when establishing a home for your Wood Lathe. Allow sufficient room to safely run your machines in any foreseeable operation.
Lighting and Outlets: Lighting should be bright enough to eliminate shadow and prevent eye strain. Electrical circuits should be dedicated or large enough to handle amperage requirements. Outlets should be located near each machine so power or extension cords are clear of high- traffic areas. Observe local electrical codes for proper installation of new lighting, out- lets, or circuits.
|
|
|
|
|
|
|
|
|
|
|
|
G1067Z Wood Lathe |