Spur Center |
| Face Plate |
|
|
|
|
|
|
The G1067Z is supplied with a #2 Morse taper spur center for use when spindle turning. The spur center is used in conjunction with the tail- stock live center. Install the spur center by insert- ing into the hole in the inboard spindle. Figure 9.
Figure 9.
To remove: insert the knockout bar provided into the outboard spindle and tap with the palm of your hand while carefully holding onto the spur center with your other hand. Figure 10.
Knockout bar
Figure 10.
The G1067Z is supplied with a 6'' face plate.The faceplate is used for bowl and plate turning. Install the face plate by threading the face plate onto the inboard spindle. Use the indexing pin to hold the spindle from rotating while tightening down or removing the face plate. Figure 11. Do not use the face plate in conjunction with the spur center. Mount your workpiece to the face plate using the mounting holes bored into the face plate.
Figure 11.
G1067Z Wood Lathe |