5.Wipe off any excess oil and
6.Loosen the quill lock handle and rotate the tailstock handwheel until the quill extends fully (approximately 31⁄2").
7.Clean the outside and inside of the quill with a rag and mineral spirits.
8.Place a few drops of light machine oil on a rag and wipe down the inside and outside of the quill so only a minimal amount of oil remains.
9.Return the quill to the prior position.
Inboard Tool Rest
Clean the tool rest shaft (Figure 53) with mineral spirits and a rag, then wipe a thin coat of light machine oil onto the shaft to distribute the oil.
Shaft
Figure 53. Location to lubricate tool rest.
To lubricate the bottom of the tool rest hold- er:
1.Loosen the tool rest lock lever, slide the tool rest holder off of the bed, then turn it over on a protected surface.
2.Clean the shaft on the underside of the tool rest holder with mineral spirits and a rag.
3.Place a couple drops of machine oil at each pivot point at the shaft ends and under the locking plate. Turn the tool rest lock lever and move the locking plate to distribute the oil (see Figure 54).
Lubrication
Locations
Figure 54. Locations to lubricate bottom of tool
rest holder.
4.Re-install the tool rest holder on the bed.
Outboard Tool Rest
1.Clean the outboard tool rest shaft and sup- port rod with mineral spirits and a rag.
2.Place several drops of light machine oil on a rag and wipe it up and down the tool rest sup- port rod (see Figure 55).
Tool Rest
Shaft
Support
Rod
Figure 55. Locations to lubricate outboard tool
rest.
3.Remove the outboard tool rest, wipe the shaft, then replace it.
Spur and Live Centers
Remove the spur center from the headstock spindle and the live center from the tailstock (see Page 22 and 23 for further details).
Clean each center with mineral spirits and a rag, the place several drops of light machine oil on a rag and wipe each center down.
Reinstall each center according to the instructions on 22 and 23.
Model G0694 (Mfg. Since 1/09)