SECTION 2: CIRCUIT REQUIREMENTS
110V Operation
Serious personal injury could occur if you connect the machine to the power source before you have completed the set up pro- cess. DO NOT connect the machine to the power source until instructed to do so.
Amperage Draw
The Model G0657/G0658 motors draw the follow- ing amps under maximum load:
G0657 Motor Draw | 6 Amps |
G0658 Motor Draw | 8 Amps |
Power Supply Circuit Requirements
We recommend connecting your machine to a dedicated and grounded circuit that is rated for the amperage given below. Never replace a circuit breaker on an existing circuit with one of higher amperage without consulting a qualified electri- cian to ensure compliance with wiring codes. If you are unsure about the wiring codes in your area or you plan to connect your machine to a shared circuit, consult a qualified electrician.
Minimum 110V Circuit Size.................... 15 Amps
Plug/Receptacle Type
Included Plug Type | NEMA |
<gdjcY^c\Egdc\^h |
|
Adc\Zhid[i]ZI]gZZ |
|
Egdc\h |
|
8jggZci 
8Vggn^c\Egdc\h <gdjcYZY
DjiaZi
Figure 2. Typical type 5-15 plug and receptacle. G0657/G0658 Benchtop Lathe
Electrocution or fire could result if this machine is not grounded correctly or if your electrical configu- ration does not comply with local and state codes. Ensure compliance by checking with a qualified electrician!
This machine must have a ground prong in the plug to ground it. DO NOT remove ground prong from plug to fit into a two- pronged outlet! If the plug will not fit the outlet, have the proper outlet installed by a qualified electrician.
Extension Cords
We do not recommend the use of extension cords, but if you find it absolutely necessary:
•Use at least a 14 gauge cord that does not exceed 50 feet in length!
•The extension cord must also contain a ground wire and plug pin.
•A qualified electrician MUST size cords over 50 feet long to prevent motor damage.