Jet Tools JWL-1642EVS-2 operating instructions Guard, Controls and Features

Guard

1.Attach guard to the bracket by inserting the rod and lifting up on the plunger (A, Fig. 5).

2.There are two detents that will hold the guard in place. One is for turning and the other is for when you need the guard up and out of the way.

3.Tighten the bushings (B, Fig. 5) against the bracket with two setscrews (C, Fig. 5).

Controls and Features

1.Headstock Lock Handle: (D, Fig. 6) Locks head in position. Unlock handle to position the head along lathe bed. Tighten handle when properly positioned.

2.Headstock Spindle Lock: (E, Fig. 6) Push pin in to keep the spindle from turning. CAUTION! Never press the headstock spindle lock while the spindle is turning!

3.Headstock On/Off Button: (F, Fig.6) Pull the button out to turn “ON” the lathe. Push the button in to turn the lathe “OFF”.

4.Headstock RPM Knob: (G, Fig. 6) Turn knob to desired RPM. There are two speed ranges offering “speed” (0-3200) and “torque” (0-1,200).

5.Headstock For/Rev Switch: (H, Fig. 6) Use the toggle switch to change the direction the spindle turns. Only change direction when the spindle has stopped.

6.Headstock RPM Readout: (I, Fig. 6) Displays the spindles RPM, see Figure 7.

7.Headstock Spur Center: (J, Fig. 8) Used for turning between centers. Spindle taper is MT-2. Remove spur center by inserting drift rod through the opposite end of the spindle and knocking spur center out.

11