Jet Tools JWL-1442VS operating instructions Controls and Features, Headstock Lock Handle E, Fig

Controls and Features

E.Headstock Lock Handle: (E, Fig. 4)

Locks the head in position. Unlock the handle to position the head in any location along the lathe bed. Tighten handle when properly positioned.

F.Headstock Indexing Pin: (F, Fig. 4

Turn the knurled knob counter-clockwise to unlock the plunger. Pull the knob out to release the headstock. Unlock the headstock-locking handle and rotate the headstock. Turn knurled knob clockwise until it stops to lock plunger.

G.Headstock Spindle Lock: (G, Fig. 5)

Push in pin to keep the spindle from turning.

Never press the headstock spindle lock while the spindle is turning!

H.Headstock On/Off Switch: (H, Fig.5)

Flip the switch up to turn “ON” the lathe. Flip the switch down to turn the lathe “OFF”.

I.Headstock On/Off Switch Key: (I, Fig. 5) Remove key when in the “OFF” position. The switch will not work until key is reinstalled.

J.Headstock Speed Selector: (J, Fig. 5)

Place handle directly above the desired RPM speed. Pull handle out and move to the desired speed, see Figure 6.

Only change speeds while the spindle is turning!

Figure 4

Figure 5

Diameter	Roughing	General	Finishing
		Cutting
of Work	RPM		RPM
		RPM
Under 2"	1500	3000	3000
2 to 4"	600	1500	2300
4 to 6"	450	1100	1500
6 to 8"	450	600	1100
8 to 10"	450	600	850
10 to 12"	450	600	850
12 to 14"	450	450	600

Figure 6

10