Jet Tools JWL-1442VS operating instructions Tool Rest, Stand Shelf

2.Thread adjustable feet (A, Fig. 1) into stand leg (B, Fig. 1). There is a flat spot on the shaft near the foot that will accommodate a wrench. Thread a hex nut (C, Fig. 1) onto shaft and leave loose for now.

3.Mount the leg to lathe bed with four 5/16” flat washers and four 5/16”-18 x 1-1/2” hex socket cap screws (D, Fig. 1).

4.Repeat for the other leg.

5.Adjust the feet so that the lathe rests evenly on the floor, and tighten the nuts.

6.Reinstall headstock, tailstock and tool rest.

Tool Rest

Secure tool rest (A, Fig. 2) to tool rest body (B, Fig. 2) by tightening handle (C, Fig. 2).

Note: For some turning applications, you may need to assemble the tool rest extension between the tool rest body and tool rest.

Stand Shelf

You can make an extra shelf that rests between the legs if you wish, see Figure 3. It will be useful for storing lathe accessories, or adding sand bags for some extra weight. The two 2x4’s should be 55- 3/4” long. The plywood should be ripped into two equal pieces 27-13/16”L x 17”W so that it can be assembled between the legs. Use screws to attach the plywood to the 2x4 supports.

8

Figure 2

Figure 3