8.5Extension wings
Referring to Figure 7:
Make sure mating surfaces are clean and free of burrs.
1.Attach right extension wing (J) to saw table using four screws and washers
2.Repeat for left side.
Figure 7
8.6Extension wing adjustment
Referring to Figure 8:
Level extension wing (J) to saw table using a straight edge (L). A metal straight edge is ideal, although a carefully jointed board may also be used, as shown.
Figure 8
1.Begin with the extension wings raised slightly higher than the main table. Tighten the four screws (13mm wrench) under the extension wing that secure it to the saw table. Tighten these just enough to hold the wing in place but loose enough to change the wing height by tapping on it.
2.Lay straight edge across saw table and extension wing, extending out past edge of wing, as shown.
3.Move straight edge to several places along the wing, as you continue to nudge the
extension wing level with saw table. When extension wing is level with table, securely tighten each of the four screws.
4.Repeat steps 1 through 3 for opposite extension wing.
5.Reinstall right side motor cover.
8.7Rails and fence
To install front and rear rails and fence, consult manual
8.8Wood extension table
To install the optional wood table, consult manual
8.9Switch bracket
Referring to Figure 9:
Use two screws and washers
Figure 9
8.10Dust Hood
Referring to Figure 10:
Install dust hood at rear of cabinet, using four small lock knobs
A dust collection system, with minimum capacity of 350 cubic feet per minute, should be connected to the port via a
An extensive line of JET dust collectors is available – contact your dealer or visit our website for information.
12