Jet Tools JPS-10TS operating instructions Table of contents

2.0Table of contents

Section				Page
1.0	Warranty and service			2
2.0	Table of contents			3
3.0	Safety warnings			4
3.1		Kickback		5
4.0	About this manual			6
5.0	Glossary			7
6.0	Features			8
7.0	Specifications			8
8.0	Setup and assembly			10
8.1		Shipping contents		10
8.2		Unpacking and cleanup		11
8.3		Installing legs		11
8.4		Handwheels		11
8.5		Extension wings		12
8.6		Extension wing adjustment		12
8.7		Rails and fence		12
8.8		Wood extension table		12
8.9		Switch bracket		12
8.10		Dust Hood		12
8.11		Riving knife		13
8.12		Anti-kickback pawls		13
8.13		Blade guard		14
8.14		Blade installation/replacement		14
8.15		Aligning blade guard and riving knife		15
8.16		Low profile riving knife		15
8.17		Table insert		15
8.18		Miter gauge		15
9.0	Electrical connections			16
9.1		Grounding instructions		16
9.2		Voltage conversion		16
9.3		Overload reset button		17
9.4		Extension cords		17
9.5		On-off switch padlock		17
10.0	Adjustments			17
10.1		Blade raising/tilt mechanism		17
10.2		Adjusting 45º and 90º positive stops		17
10.3		Table to blade alignment		19
11.0	Operations			19
12.0	Safety devices			24
13.0	Maintenance			25
14.0	Optional accessories			26
15.0	Troubleshooting the JPS-10TS			27
16.0	Replacement Parts			27
16.1.1 Motor and Trunnion – Exploded View				28
16.1.2			Motor and Trunnion – Parts List	29
16.2.1			Table and Cabinet – Exploded View	32
16.2.2			Table and Cabinet – Parts List	33
16.3.1			Stand Assembly – Exploded View	35
16.3.2			Stand Assembly – Parts List	35
16.4.1			Cast Iron Wings – Exploded View	36
16.4.2			Cast Iron Wings – Parts List	36
17.1	Electrical Connections – 115V			37
17.2	Electrical Connections – 230V			38

3