Jet Tools JPS-10TS Maintenance, Cleaning, Weekly, Lubrication, Miscellaneous

Page 25

 

13.0

Maintenance

 

 

Always disconnect power to

 

the machine before performing maintenance.

 

Failure to do this may result in serious

 

personal injury.

 

Cleaning

 

Clean the JPS-10TS according to the schedule

 

below to ensure maximum performance.

 

Note—The following maintenance schedule

 

assumes the saw is being used every day.

 

Daily:

 

 

ˆ Wipe down the table surface and T-slots

 

with a rust preventive.

 

ˆ Clean pitch and resin from the saw blade.

 

Weekly:

 

ˆ Clean motor housing with compressed air.

 

ˆ Wipe down fence rails with a dry silicon

 

lubricant.

 

Lubrication

 

Lubricate the areas indicated below every 12

 

months.

 

 

ˆ Lubricate blade angling trunnions with 6 or

 

7 drops of light machine oil.

 

ˆ Lubricate the blade height trunnion with 6

 

or 7 drops of light machine oil.

 

ˆ Worm gears and threads should be

 

lubricated with an automotive wheel

 

bearing grease.

 

Check all adjustments after lubricating.

Figure 45 – Push stick template

Miscellaneous

Always

be aware of the condition of your

 

machine. Routinely check the condition of the

 

following items and repair or replace as

 

necessary:

ˆ Mounting bolts ˆ Power switch ˆ Saw blade

ˆ Blade guard

25

Image 25
Contents Inch ProShop Table Saw with Riving Knife More Information Warranty and serviceTable of contents Safety warnings Kickback Prevention KickbackProtection Tips from Kickback About this manual Glossary 708495K Features SpecificationsArbor and blade Shipping contents Setup and assemblyInstalling legs Unpacking and cleanupHandwheels Switch bracket Extension wing adjustmentExtension wings Rails and fenceRiving knife Use care when working around an installed bladeAnti-kickback pawls Blade guard Blade installation/replacementLow profile riving knife Aligning blade guard and riving knifeTable insert Miter gaugeGrounding instructions Electrical connectionsVoltage conversion Adjustments Page Table to blade alignment OperationsKickbacks Rip sawing Page Crosscutting ResawingDo not use the standard table insert for dadoing operations Bevel and miter operationsFeather board Safety devicesFiller piece Push stick & push blockCleaning MaintenanceWeekly LubricationOptional accessories Replacement Parts Troubleshooting the JPS-10TSSymptom Possible Cause Correction Motor and Trunnion Exploded View Index No Description Size Qty Motor and Trunnion Parts ListJPS10TSR -174MF JPS10TSR-HP Table and Cabinet Exploded View JPS10TSR-TIA Table and Cabinet Parts ListJPS10TSR-AKPA Stand Assembly Exploded View Stand Assembly Parts List Cast Iron Wings Exploded View Cast Iron Wings Parts List Electrical Connections Electrical Connections Page Walter Meier Manufacturing Inc
Related manuals
Manual 2 pages 55.36 Kb Manual 32 pages 51.66 Kb