Delta 36-585 instruction manual

Page 19

Fig. 55

Fig. 56

2.The brushes are located in two holders (C) Fig. 55. Remove the spade type terminal connectors (D) and pull the brush holders (C) out.

3.Inspect the brush (E) Fig. 56 that was removed from the holder (C). When the carbon on either brush (E) is worn to 3/16″ or if either spring (F) or shunt wire is burned or damaged in any way, replace both brushes. If the brushes are serviceable after removing, reinstall them in the same position.

Image 19

Contents Dual Bevel Compound Miter Saw Important Safety Instructions Safety Guidelines DefinitionsStay ALERT, Watch What YOU are Doing Failure to Follow These Rules MAY Result in Serious Injury Additional Safety Rules for Miter SawsPower Connections Foreword Unpacking and CleaningAssembly Carton ContentsFastening Machine to Supporting Surface Rear SUPPORT/STABILIZER & Carrying HandleDust BAG Work ClampStarting and Stopping Miter SAW Operating Controls and AdjustmentsLocking Switch in the OFF Position Hazard ZoneTilting Cuttinghead for Bevel Cutting Adjusting PointerRotating Table for Miter Cutting Pointer and ScaleSliding Fence Adjusting 90 and 45 Degree Bevel StopsAdjusting Fence 90 Degrees to the Table Auxiliary Wood Fence Adjusting Tension of Cuttinghead Return SpringOperations Helpful HintsGeneral Cutting Operations Side SupportsRight Wrong Cutting AluminumCutting Bowed Material RightIllustrates the two outside corner pieces Cutting Crown MouldingLocking Cuttinghead in the Down Position MaintenanceStorage Blade Changing Wrench StorageS C O N N E C T M a C H I N E F R O M Power Source Brush Inspection and ReplacementPage PARTS, Service or Warranty Assistance AccessoriesCanadian PORTER-CABLE Delta Service Centers