Delta 36-585 instruction manual Carton Contents, Assembly

Page 7

CARTON CONTENTS

5

1

2

4

6

3

Fig. 2

Remove the miter saw and all loose items from the carton.

Lifting the miter saw by the switch handle can cause misalignment. Always lift the machine by the base or the carrying handle (4) Fig. 2).

1.

Miter Saw

4.

Rear Support/Stabilizer

2.

Work Clamp

 

& Carrying Handle

3.

Dust Bag

5.

1/2" Arbor Nut Wrench

 

 

6.

Cotter Pin (2)

ASSEMBLY

For your own safety, do not connect the machine to the power source until the machine is completely assembled and you read and understand the entire instruction manual.

A

A

C

Fig. 3

Fig. 4

7

Image 7
Contents Dual Bevel Compound Miter Saw Important Safety Instructions Safety Guidelines DefinitionsStay ALERT, Watch What YOU are Doing Failure to Follow These Rules MAY Result in Serious Injury Additional Safety Rules for Miter SawsPower Connections Foreword Unpacking and CleaningAssembly Carton ContentsFastening Machine to Supporting Surface Rear SUPPORT/STABILIZER & Carrying HandleDust BAG Work ClampStarting and Stopping Miter SAW Operating Controls and AdjustmentsLocking Switch in the OFF Position Hazard ZoneTilting Cuttinghead for Bevel Cutting Adjusting PointerRotating Table for Miter Cutting Pointer and ScaleSliding Fence Adjusting 90 and 45 Degree Bevel StopsAdjusting Fence 90 Degrees to the Table Auxiliary Wood Fence Adjusting Tension of Cuttinghead Return SpringOperations Helpful HintsGeneral Cutting Operations Side SupportsRight Wrong Cutting AluminumCutting Bowed Material RightIllustrates the two outside corner pieces Cutting Crown MouldingLocking Cuttinghead in the Down Position MaintenanceStorage Blade Changing Wrench StorageS C O N N E C T M a C H I N E F R O M Power Source Brush Inspection and ReplacementPage PARTS, Service or Warranty Assistance AccessoriesCanadian PORTER-CABLE Delta Service Centers