7.If an adjustment is necessary, remove screw (R) Fig. 23, loosen locknut (S) and turn leveling screw (T) to raise or lower table mounting bracket (N). When adjust- ment is complete, tighten locknut (S) and replace screw
(R).
8.Check and adjust the other table mounting bracket in the same manner. IMPORTANT: Do not raise or lower the track arm assembly while checking or making the ad- justments.
9.Place a straight edge (V) Fig. 24, on table mounting brackets (N) as shown and adjust two center positions
(W) if necessary in the same manner on both brackets.
ASSEMBLING
TABLE CLAMPS AND
TABLE CLAMP RODS
1.Unscrew the metal clamps from the table clamp rods packed with the saw.
2.Position the metal clamp (A) Fig. 25, on the end of table mounting bracket (B). NOTE: Assemble metal clamp (A) so threaded hole (C) is on the inside of table mounting bracket.
3.Insert threaded end of table clamp rod (D) Fig. 26, through metal support (E) at the front of the saw and thread rod through the tapped hole in table clamp (A) as shown.
4.Assemble the remaining table clamp and table clamp rod to the other side of the table in the same manner. Do not tighten the table clamp rods at this time.
R
N
T
S
Fig. 23
NV
NW
Fig. 24
B A
C
Fig. 25
AD
E
Fig. 26
12