Delta 33-890, 33-892, 33-891 instruction manual Pushstick, Constructing a Push Stick

Page 25

CONSTRUCTING A PUSH STICK

When ripping work less than 4 inches wide, a push stick should be used to complete the feed and could easily be made from scrap material by following the pattern shown.

PUSHSTICK	MAKEFROM1/2"OR3/4" WOODORTHICKNESS LESSTHANWIDTHOF MAT’L.TOBECUT		NOTCHTOHELP PREVENTHAND FROMSLIPPING
	CUTOFFHERETO PUSH1/4"WOOD	CUTOFFHERETO PUSH1/2"WOOD	1/2"SQUARES

25

Image 25

Contents Radial Arm Saw General Safety Rules Additional Safety Rules for Radial ARM Saws Motor Specifications Power ConnectionsGrounding Instructions Extension Cords Unpacking and CleaningOperating Controls Assembling Steel Legs to Base AssemblyAssembling Overarm Elevating Handle Assembling Cuttinghead To Track ARM Illustrates the starter box assembled to the base Assembling Starter BOX to BaseAdjusting Table Brackets Parallel to Track ARM Page Assembling Table Clamps Table Clamp Rods Assembling Table Boards Assembling SAW Blade and Blade Guard AssemblyPage ON/OFF Switch Operating Controls and AdjustmentsAdjusting Overarm Column Assembly Adjusting Yoke Clamp HandleAdjusting Track Rods Adjusting Cuttinghead Ball Bearings Against Track RodsAdjusting Blade Square with Table TOP Adjusting Track ARM Clamp Handle Adjusting SAW Travel Square with Fence CROSS-CUT Stop Removing Heeling in SAW CUTAdjusting Track ARM Stop Adjusting Blade Guard and ANTI-KICKBACK RODCROSS-CUTTING Assembling Accessory 33-967 Moulding Cutterhead GuardCompound Miter Cutting Miter CuttingRipping OUT-RIPPINGIN-RIPPING Constructing a Push Stick PushstickPage Accessories PARTS, Service or Warranty Assistance Canadian PORTER-CABLE Delta Service Centers

Related manuals

Manual 84 pages 6.57 Kb