Delta 33-891, 33-892, 33-890 instruction manual

Page 14

5.Remove screw, flat washer and spacer (G) Fig. 31, that fasten the front inside leaf guard (H) to front end of blade guard (J). Assemble blade guard (J) to motor assembly with locking rod (K).

6.Reassemble leaf guard (H) Fig. 31, to blade guard (J) using screw, flat washer and spacer (G).

7.Fig. 32, illustrates the blade guard assembly attached to the motor assembly.

K

J

HG

Fig. 31

Fig. 32

NOTE: The lower retractable blade guard provides opera- tor protection in an axial direction to the saw blade. Care must be taken to eliminate potential hazards of the lower blade guard.

A)KEEP YOUR HANDS AWAY FROM THE GUARD. As the blade cuts, the guard will lift and leave part of the blade exposed.

B)SHUT OFF POWER BEFORE FREEING A JAMMED LOWER GUARD. The guard can get jammed in previous kerfs in table or fence. Always anticipate the path of the guard.

C)USE CAUTION when making bevel cuts to be sure the lower guard is never pinched towards the blade.

D)THE LOWER GUARD CAN JAM AGAINST THE FENCE DURING NARROW IN-RIPS. Should the guard jam against the fence, disconnect the saw from power source, wait for the blade to stop, then lift the blade guard and rest it on top of the fence.

14

Page 13 Page 15
Image 14
Page 13 Page 15
Contents Radial Arm Saw General Safety Rules Additional Safety Rules for Radial ARM Saws Grounding Instructions Power ConnectionsMotor Specifications Unpacking and Cleaning Extension CordsOperating Controls Assembling Overarm Elevating Handle AssemblyAssembling Steel Legs to Base Assembling Cuttinghead To Track ARM Assembling Starter BOX to Base Illustrates the starter box assembled to the baseAdjusting Table Brackets Parallel to Track ARM Page Assembling Table Clamps Table Clamp Rods Assembling SAW Blade and Blade Guard Assembly Assembling Table BoardsPage Adjusting Overarm Column Assembly Operating Controls and AdjustmentsON/OFF Switch Adjusting Yoke Clamp HandleAdjusting Cuttinghead Ball Bearings Against Track Rods Adjusting Track RodsAdjusting Blade Square with Table TOP Adjusting Track ARM Clamp Handle Adjusting SAW Travel Square with Fence Removing Heeling in SAW CUT CROSS-CUT StopAdjusting Blade Guard and ANTI-KICKBACK ROD Adjusting Track ARM StopAssembling Accessory 33-967 Moulding Cutterhead Guard CROSS-CUTTINGRipping Miter CuttingCompound Miter Cutting OUT-RIPPINGIN-RIPPING Pushstick Constructing a Push StickPage Accessories PARTS, Service or Warranty Assistance Canadian PORTER-CABLE Delta Service Centers
Related manuals
Manual 84 pages 6.57 Kb
Top Page Image Contents