Delta 33-892, 33-890, 33-891 instruction manual In-Ripping

Page 24

IN-RIPPING

In-ripping involves all of the general conditions stated under RIPPING. The yoke is clamped at right angle to the track arm with the blade guard facing the rear of the machine. The cuttinghead is positioned on the in-rip scale to the desired setting and clamped in position. The workpiece is fed from the right side of the saw. Fig. 66, shows a typical in-ripping operation on the radial saw. Note the push stick is being used due to the narrow workpiece.

BC

Fig. 66

24

Image 24

Contents Radial Arm Saw General Safety Rules Additional Safety Rules for Radial ARM Saws Power Connections Motor SpecificationsGrounding Instructions Unpacking and Cleaning Extension CordsOperating Controls Assembly Assembling Steel Legs to BaseAssembling Overarm Elevating Handle Assembling Cuttinghead To Track ARM Assembling Starter BOX to Base Illustrates the starter box assembled to the baseAdjusting Table Brackets Parallel to Track ARM Page Assembling Table Clamps Table Clamp Rods Assembling SAW Blade and Blade Guard Assembly Assembling Table BoardsPage Operating Controls and Adjustments ON/OFF SwitchAdjusting Overarm Column Assembly Adjusting Yoke Clamp HandleAdjusting Cuttinghead Ball Bearings Against Track Rods Adjusting Track RodsAdjusting Blade Square with Table TOP Adjusting Track ARM Clamp Handle Adjusting SAW Travel Square with Fence Removing Heeling in SAW CUT CROSS-CUT StopAdjusting Blade Guard and ANTI-KICKBACK ROD Adjusting Track ARM StopAssembling Accessory 33-967 Moulding Cutterhead Guard CROSS-CUTTINGMiter Cutting Compound Miter CuttingRipping OUT-RIPPINGIN-RIPPING Pushstick Constructing a Push StickPage Accessories PARTS, Service or Warranty Assistance Canadian PORTER-CABLE Delta Service Centers

Related manuals

Manual 84 pages 6.57 Kb