Delta 33-890, 33-892 Assembling Table Boards, Assembling SAW Blade and Blade Guard Assembly

ASSEMBLING

TABLE BOARDS

1.Place main table board (A) Fig. 27, on the table mounting brackets making sure that the two roll pins in the table mounting brackets fit into the two holes in bottom of main table board (A). Fasten table in place, place a 1/4" flat washer onto a 1/4-20x1-3/4" round head screw and insert the screws through holes (B) predrilled in the main table board (A) and tighten securely.

2.Place the remaining loose boards (C) Fig. 28 and fence (D) on the table mounting brackets, and tighten the two table clamp rod knobs (E). Fence (D) can be repositioned as required.

ASSEMBLING SAW BLADE AND BLADE GUARD ASSEMBLY

WARNING: USE 12” BLADES ONLY, RATED FOR AT LEAST 3450 RPM.

1.DISCONNECT TOOL FROM POWER SOURCE.

2.Remove arbor nut (A) Fig. 29, and outside blade flange (B). NOTE: THE BLADE IS TO BE ASSEMBLED

BETWEEN THE TWO BLADE FLANGES (B) AND (C) WITH THE RECESSED SIDES OF THE FLANGES AGAINST THE SAW BLADE.

3.Assemble the saw blade (D) Fig. 30, between the two blade flanges making sure the teeth of the saw blade are pointing down at the front.

4.Assemble arbor nut (A) Fig. 30 to shaft and tighten with wrench (E) Fig. 30, while keeping arbor shaft from turning with other wrench (F).

A

B

B

Fig. 27

DC

E

E

Fig. 28

C

B

A

Fig. 29

D

A

E

F

Fig. 30

13