Delta 36-465 Assembling Motor PULLEY, Belt Pulley GUARD, and Drive Belt, To Motor Mounting Plate

ASSEMBLING MOTOR

PULLEY, BELT PULLEY GUARD, AND DRIVE BELT

DISCONNECT MACHINE FROM THE POWER SOURCE.

1.Remove the motor shaft key that is taped to the motor.

2.Insert the key (A) Fig. 15 in the keyway on the motor shaft. Assemble the motor pulley (B) on the motor shaft with the hub of the pulley facing out. Tighten set screw

(C).

3.Remove wing nut and external tooth lockwasher (D) Fig. 16, and outer cover (E) from belt and pulley guard (G).

4.Slide the belt and pulley guard bracket (G) Fig. 17 between the motor plate (M) and motor mounting plate (L), as shown.

5.Position belt and pulley guard bracket (G) Fig. 17, so that the motor pulley (B) is centered and through the hole in the belt and pulley guard bracket.

6.Use a straight edge (E) to align the motor pulley (B) Fig. 18 with the arbor pulley (G). If necessary, adjust the motor pulley (B) in or out on the motor shaft. Tighten the four hex nuts that fasten the motor to the motor mounting plate. See section “ASSEMBLING MOTOR

TO MOTOR MOUNTING PLATE”.

BA

C

Fig. 15

E

GD

Fig. 16

G

B

M

L

Fig. 17

G

E

B

Fig. 18

13