Delta 28-195 instruction manual Tilting the Table, Adjusting Table Positive Stops

TILTING THE TABLE

The table can be tilted 48 degrees to the right and approximately 3 degrees to the left. To tilt the table, loosen lock handle (A) Fig. 27, tilt the table to the desired angle and tighten lock handle (A). NOTE: The table lock handle (A) can be repositioned by pulling out on the handle and repositioning it on the nut located underneath the hub of the handle. A scale (B) and pointer (C) is provided to indicate the degree of table tilt.

ADJUSTING TABLE

POSITIVE STOPS

Positive stops are provided for the table at the 90 and 45 degree angle to the blade. To check and adjust the positive stops, proceed as follows:

1. Tilt the table to the 90 degree position (all the way to

the rear) and tighten lock handle (A) Fig. 28. Place a

square (B) on the table and against the blade and check

to see if the blade is 90 degrees to the table surface. If

C

A

B

Fig. 27

B

C

A

Fig. 28

an adjustment is necessary, proceed as follows:

2. Tilt the table slightly forward as shown in Fig. 29.

Loosen lock nut (B) and using wrench provided, turn

adjusting screw (C) Figs. 28 and 29, from top of table until

bottom of screw (C) contacts surface (D) when blade is

90 degrees to the table. Then tighten lock nut (B).

3. Tilt the table to the 45 degree position (all the way to

the front) as shown in Fig. 30. Place a square (B) on the

table and against the blade and check to see if the blade

is 45 degrees to the table surface. If an adjustment is

A

B

C

D

necessary, proceed as follows:

4. Loosen lock nut underneath table on bottom of

adjusting screw (E) Fig. 30, and turn adjusting screw (E)

with wrench (F) provided, until blade is 45 degrees to the

table. After adjustment is completed, tighten lock nut

underneath table on bottom of screw (E).

Fig. 29

B

FE

Fig. 30

15