Craftsman owner manual CliaFTtHIIIr RADIALSAW315.220380

	Attaching Elevating Handwheel		23
	Installing the Yoke Assembly		24
	Removing the Blade		25
	Attaching Table Supports		25
	Setting the Arm Lock Knob		26
	Setting the Yoke Claml)		26
	Setting the Bevel Lock Lever		27
	Tightening the Arm and Column		28
	Adjusting the Column Tube		28-29
	Adjusting the Carriage Bearings		30
	Leveling the Table Supports		31
	Installing the Front Table		32
	Leveling the Front Table		33
	Installing Rear Table, Spacer Table, Fence, and Clamps	:	33-34
	Installing Blade and Blade Guard		34
	Aligning Riving Knife to Blade		35
	Installing Rip Scale Indicators		36
•	Adjustments		36-42
	Aligning the Arm for Cross Cuts		37
	Aligning the Blade to Table at 0" Bevel		38
	Squaring Blade to Fence		39
	Paralleling Blade to Table		40
	Aligning the Rip Scale Indicators		41
	Installing Control Cut Device		42
•	Operation		43-53
	Basic Operation of the Radial Arm Saw		43
	Types of Cuts		43
	Switch and Switch Key		44
	Causes of Kickback		44
	Avoiding Kickback		44
	Cutting Aids		45
	Making a Cross Cut		46
	Making a Miter Cut		47
	Making a Bevel Cut		48
	Making a Compound Cross Cut		49
	Rip Cut Hazards and Precautions		50
	Setting Up a Rip Cut		50-51
	Making a Rip Cut		51
	Making Other Cuts		52
	Cutting Long Workpieces		52
	Non-Through Cuts		53
•	Maintenance		54
•	Troubleshooting		55-59
•	Exploded View and Repair Parts List		60-81
•	Parts Ordering / Service		back page

3 CliaFTtHIIIr RADIALSAW315.220380