Zenoah HC510DV manual Symbols on the machine,  6 

Page 6

4. Symbols on the machine

(a)

(b)

(c)

IMPORTANT ENGINE INFORMATION

THIS ENGINE CONFORMS TO U.S. EPA PH1 FOR SMALL OFF-ROAD ENGINES.

ENGINE FAMILY : 3KZXS. 0494LM ; EM

ENGINE DISPLACEMENT : 49.3cm3

REFER TO OWNER’S MANUMAL FOR MAINTE- NANCE SPECIFICATIONS AND ADJUSTMENTS.

MANUFACTURED:

RedMax Made in Japan

WARNING

For safe operation and maintenance, symbols are indicated on the machine. According to these indications, please be careful not to take a mistake.

(a)The port to refuel the "MIX GASOLINE" Position: FUEL TANK CAP

(b)Choke will close when pulling the choke knob Position: CHOKE KNOB

(c)It indicates the start (I) and stop (O) direction Position: SWITCH

INFORMATION IMPORTANTE CONCERNANT LE MOTEUR

Ce moteur conformc aux normcs U.S. EPA

PH1 pour les petits moteurs tout-terrain.

Type de moteur : 3KZXS. 0494LM ; EM

Cylindrée du moteur : 49.3cm3

Se référer au Manuel de l'utilisateur pour les spécifications d'entretien et les réglages.

Manufacturé :

RedMax Made in Japan

6 

Image 6

Contents HC510DV 848-C8X-93A1Page Safety First ContentsSpecifications Parts location 4   5  Symbols on the machine  6 Before Using the Machine For safe operation 7  Working Gear and Clothing  8  9  Operation Safety Precautions  10 Maintenance Safety Precaution After Using the SAW 11  Change of Dust Stopper Set upSE1  12 Fitting Dust Hose and Dust BAG SE2 SE3 SE4 Mounting of Cutter BladeCutter blade Flange bolt Flange washer a Dust hose Metal band Dust bag Tying CordFuel When using Zenoah genuine oilHOW to MIX Fuel  14 Fueling the Unit For Your Engine LIFE, AvoidClose OperationOP1 OP2 Starting Engine  16 OP3 OP4 Decomp valve 17  Stopping Engine SwitchOP5 OFFFront guide Horizontal Cutting OP6 OP7 Cutting OperationFor AN Efficient Cutting Operation Vertical CuttingAir cleaner cover Top plate Felt filter MaintenanceAIR Cleaner MA1Spark Plug MA2MA3 NGK BPM8YCooling AIR Passage MA4 MA5 22  Blade Drive BeltDisassembling Procedure MA6 MA7 MA8 MA9Belt Exchange Assembling Procedure  24 MA14 FAN Drive Belt Belt Tension Adjustment and ExchangeIdler pulley Belt adjustment plate Bolt Tighten Slacken  25 MA15 Engine Adjustment MA15When adjusting, take the following steps  26  27  Starter Rope Exchange  28 MA19 MA20 MA21 Notch 30  Storage  31 Troubleshooting guide Check Probable Causes Action 32  Parts list  33 Cutter Unit HC510DV S/N 200101 and up  34  35  Power Unit 1 HC510DV S/N 200101 and up  36  37  Power Unit 2 HC510DV S/N 200101 and up  38  39  Carburetor HC510DV S/N 200101 and up  40 Accessories & Tool SET HC510DV S/N 200101 and up  41 Manufacturer’s warranty coverage Limited Warranty RedMax Garantie limitée