Zenoah HC510DV manual Set up, SE1, Change of Dust Stopper,  12 

Page 12

6. Set up

SE1

WARNING

Use adequate cutter blades suited to materials to be cut. Use of inadequate cutter blades may cause irregular wear of blades, poor cutting performances, or irregular overheating, etc. Continuance of those inadequate operations may damage the blades and cause serious accidents.

■CHANGE OF DUST STOPPER

IMPORTANT

•To apply 12 inch blades, the dust stopper L (on the engine starter side) shall be exchanged with an attached 12 inch version before fitting blades.

•In case the dust stopper is unchanged, dust collection performances become poor.

(1)14 inch version dust stopper

(2)Screw

(3)Mounting bracket

(a)Remove 14 inch version dust stopper

(b)Fix 12 inch version dust stopper

1.Remove a dust stopper fixed left inside of the blade cover.

2.Remove a stopper element from a dust stopper mounting bracket. Properly fix an attached 12 inch version stopper element on the mounting bracket.

3.Reassemble the dust stopper to the blade cover as original.

NOTE

Securely keep the removed dust stopper element as it is required for 14 inch blade operations.

12 

Image 12

Contents HC510DV 848-C8X-93A1Page Safety First ContentsSpecifications Parts location 4   5  Symbols on the machine  6 Before Using the Machine For safe operation 7  Working Gear and Clothing  8  9  Operation Safety Precautions  10 Maintenance Safety Precaution After Using the SAW 11  Set up SE1Change of Dust Stopper  12 SE2 SE3 SE4 Mounting of Cutter Blade Cutter blade Flange bolt Flange washer aFitting Dust Hose and Dust BAG Dust hose Metal band Dust bag Tying CordWhen using Zenoah genuine oil HOW to MIX FuelFuel  14 Fueling the Unit For Your Engine LIFE, AvoidOperation OP1 OP2 Starting EngineClose  16 OP3 OP4 Decomp valve 17  Switch OP5Stopping Engine OFFOP6 OP7 Cutting Operation For AN Efficient Cutting OperationFront guide Horizontal Cutting Vertical CuttingMaintenance AIR CleanerAir cleaner cover Top plate Felt filter MA1MA2 MA3Spark Plug NGK BPM8YMA4 MA5  22 Cooling AIR Passage Blade Drive BeltDisassembling Procedure MA6 MA7 MA8 MA9Belt Exchange Assembling Procedure  24 FAN Drive Belt Belt Tension Adjustment and Exchange Idler pulley Belt adjustment plate Bolt Tighten SlackenMA14  25 Engine Adjustment MA15 When adjusting, take the following stepsMA15  26  27  Starter Rope Exchange  28 MA19 MA20 MA21 Notch 30  Storage  31 Troubleshooting guide Check Probable Causes Action 32  Parts list  33 Cutter Unit HC510DV S/N 200101 and up  34  35  Power Unit 1 HC510DV S/N 200101 and up  36  37  Power Unit 2 HC510DV S/N 200101 and up  38  39  Carburetor HC510DV S/N 200101 and up  40 Accessories & Tool SET HC510DV S/N 200101 and up  41 Manufacturer’s warranty coverage Limited Warranty RedMax Garantie limitée