STOWTRAK 20 SAW — STARTUP/SHUTDOWN (ELECTRIC MOTORS)
Start-up (Electric Motor)
CAUTION - Read this Manual before Starting!
Read and fully understand this manual before starting or attempting to operate the saw.
Before starting the saw's electric motor make sure that the Safety, General Information, Inspection and
sections have been completed and understood. DO NOT proceed until the above mentioned sections have been completed.
DANGER - Amputation Hazard
NEVER place hands and fingers near the cutting blade.The possibility exists of severe bodily harm if hands and fingers come in contact with rotating saw blade.
2.Avoid overloading the motor when cutting. The electric motors are protected with a
Shutdown Procedure
1.Place the power ON/OFF switch (Figure 18) in the OFF position (down).
Figure 18. Power ON/OFF Switch (OFF)
CAUTION - Blade Guard Safety
ALWAYS ensure that the cutting blade has been mounted correctly and that it is raised above the surface you are about to cut.
1.Turn the power ON/OFF switch (Figure 17) to the ON position with the blade away from the material to be cut, the cutting blade should begin to rotate. Before cutting remember to follow all safety rules referenced in this manual.
2.Wait for the cutting blade to stop rotating.
3.Disconnect the saw's AC power cord from the power source.
CAUTION - Leaving the Saw Unattended
NEVER leave the saw connected to a power source when unattended. This will prevent accidental starting and potential injury.
4.Using a soft cloth, clean any excess debris or residue that may have accumulated on the saw.
5.Store saw in a clean dry location where it will be out of the reach of children.