Kuhn Rikon 10" Cabinet Saw Sliding Table, 10-110B/E Rip Fence Installation, Maintenance

Page 15

Rip Fence Installation

Fence Bar Placement with Sliding Table

With the sliding table installed the front and rear fence bars must be relocated. Align the notches in the fence bars with the right miter slot in the main table. (A-Fig. 26)

Follow the fence installation instructions found on page nine of the 10-110/10-050 Cabinet Saw manual.

A

Figure 26

Maintenance

Caution! BEFORE CLEANING OR CARRYING OUT MAINTENANCE WORK, DISCONNECT THE MACHINE FROM THE POWER SOURCE (WALL SOCKET). NEVER USE WATER OR OTHER LIQUIDS TO CLEAN THE MACHINE. USE A BRUSH. REGULAR MAINTENANCE OF THE MACHINE WILL PREVENT UNNECESSARY PROBLEMS.

Keep the table clean to ensure accurate cutting.

Keep the table mounting area clean to ensure accurate operation of all moving parts and prevent excessive wear.

Check sliding table alignment to the table saw work surface to correct or prevent rubbing. Keep the inside (near the saw blade, etc.) clean to prevent accumulation of dust.

15

Image 15
Contents Cabinet Saw Sliding Table General Safety Warnings Operator Safety Required ReadingRefer to them often Table Saw Safety RulesTable of Contents Unpacking and Checking Contents Content of PackageBox #2 Getting To Know Your Sliding Table Mounting the Sliding Table AssemblyInstalling the Swing Arm Extension Bar Mounting the Swing Arm BracketInstalling the Sliding Table Carriage Carriage Table Support Arm Installation Installing the Sliding Table Miter Fence Leveling the Sliding Table Carriage AdjustmentInstalling the Sliding Table Locking Pin Leveling the Sliding Table to the SawLocking and Unlocking the Slide Table OperationSlide Table Clearance to Saw Blade Locking knobCutting Sheet Goods Cross CuttingMiter Cuts Rip Fence Installation MaintenanceFence Bar Placement with Sliding Table Troubleshooting Parts Diagram Key Description Key Part No Parts ListYear Limited Warranty WarrantyFor more information