Kuhn Rikon 10" Cabinet Saw Sliding Table, 10-110B/E Operation, Slide Table Clearance to Saw Blade

Page 13

Adjustment

Slide Table Clearance to Saw Blade

1.Place a square on the front edge of the sliding table. (A-Fig. 20)

2.Push the sliding table until the top of the square clears the back edge of the leading tooth on the saw blade. (B-Fig. 20)

3.If the square does not clear the back edge of the leading tooth on the saw blade, loosen the two locking knobs under the slide table. Move the table support forward or backwards until the aligment is correct. (A-Fig. 21)

B

A

Figure 20

Locking knob

Figure 21

Operation

Locking and Unlocking the Slide Table

WARNING! Keep the sliding table locked when not in use. Failure to do so could cause serious

injury.

To lock the sliding table, pull the locking pin out- ward, twist and insert pin into the locking hole in the table carriage. (Fig. 22)

To unlock the sliding table, pull the locking pin out-

ward, twist and rest the cross pin into the seat ofFigure 22 the lock knob body. (Fig. 22)

13

Page 12 Page 14
Image 13
Page 12 Page 14
Contents Cabinet Saw Sliding Table General Safety Warnings Operator Safety Required ReadingRefer to them often Table Saw Safety RulesTable of Contents Unpacking and Checking Contents Content of PackageBox #2 Getting To Know Your Sliding Table Installing the Swing Arm Extension Bar AssemblyMounting the Swing Arm Bracket Mounting the Sliding TableInstalling the Sliding Table Carriage Carriage Table Support Arm Installation Installing the Sliding Table Miter Fence Installing the Sliding Table Locking Pin AdjustmentLeveling the Sliding Table to the Saw Leveling the Sliding Table CarriageSlide Table Clearance to Saw Blade OperationLocking knob Locking and Unlocking the Slide TableCross Cutting Cutting Sheet GoodsMiter Cuts Maintenance Rip Fence InstallationFence Bar Placement with Sliding Table Troubleshooting Parts Diagram Key Description Key Part No Parts ListYear Limited Warranty WarrantyFor more information
Top Page Image Contents