Assembly
Carriage Table Support Arm Installation
1.Insert the support arm into the swing arm extension bar as shown (A, Fig. 9) making sure that bearing assembly rests between the adjusting nuts and the swing arm extension bar (B, Fig. 9).
Reminder: Tighten the carriage bolts shown in Figure 8 on page nine once the support arm is installed.
2.Hold the support arm in place by installing the second bearing set and adjusting nuts as shown. The second set of bearings should be installed against the bottom side of swing arm extension bar. Figure 10.
NOTE: Do not overtighten the adjusting nuts as the bearings will bind and the table will not slide smoothly.
3.Hold the sliding table carriage against the sliding table and install the lock knobs through the carriage to the
4.Line up the two holes in the side of the support arm with the two holes in the side of the sliding table carriage (Fig. 12).
5.Insert the two locking knobs with the long threaded ends as well as two 6MM washers through the support arm and through the sliding table carriage (Fig. 12). Attach with with two 6MM washers and two 6MM hex nuts.
A
B
Figure 9
Figure 10
Figure 11
Figure 12
10