Step 5d. Remove the ceramic wire nuts from the wires and set aside for use in the next two steps.
•Attach the WHITE wire on the socket plate to the
WHITE wire coming from the bottom of the motor. Secure with a ceramic wire nut.
•Attach the WHITE wire on the socket plate to the
BLACK wire with white stripe coming from the bottom of the motor. Secure with a ceramic wire nut.
Step 5e. Carefully tuck in the wires so they do not get pinched. Align the three holes on the socket plate with the screw holes on the switch housing. Insert three socket plate screws (Pack E) and tighten until secure using the screwdriver as shown in Figure #1.
Socket Plate
Figure #1
Ceramic
Wire Nuts
Socket Plate
Screws
glass Installation |
| |
|
|
|
Install Halogen Bulb | Lightbulb |
|
Step 6a. Insert one end of the halogen bulb into the | Sockets |
|
|
| |
socket. Push the end of the socket, then insert the |
|
|
other side of the halogen bulb into the socket. as |
|
|
shown in Figure #2. |
|
|
Step 6b. Install the glass shield by pushing it into |
|
|
place with the clips on the light socket as shown in |
|
|
Figure #3. |
|
|
| Halogen | Figure #2 |
| Lightbulb | |
CAUTION:
The halogen bulb is very delicate and should not be handled with bare hands. After removing it from the box, grasp it gently by the plastic covering or a soft cloth.
NOTE: In compliance with US Federal Energy Regulations, this ceiling fan contains a device that restricts the light fixture to a maximum of 190 watts. Exceeding that limit or the marked limit on this product may result in a fire hazard or improper operation.
Halogen
Lightbulb
Lightbulb | Figure #3 |
Shield |
|
14
