Changing Transmitter Frequency Setting
Note: All fans leave the factory set to “00000.”
You will only have to change the dip switch settings in the remote if you are using more than one fan in the same area and want to control them separately.
Step 1. At the circuit breaker or fuse box, turn the power off for the fan you want to change.
Step 2. Open the battery door of the Versa•Touch control and remove the batteries.
Step 3. Change the dip switch settings, assuring that they are different from the previously installed Versa•Touch fan.
Step 4.
Step 5. At the circuit breaker or fuse box, turn the power back on for the fan whose frequency you are changing.
Step 6. Within 20 seconds of restoring power, push the High, Med, and Low buttons (in that order).
Note: You may want to label your controls to assure you do not mix them up.
If the fan is not functioning after installation:
Step 1. Check to make sure that batteries are installed correctly in the control.
Step 2. Turn the power off to the fan (from the circuit breaker) for at least 5 seconds.
Step 3. Turn the power back on (at the circuit breaker) and push the High, Med, and Low
Step 4. The fan should now function properly.
Versa•Touch 2
Control
(back)
Dip Switch | Dip Switch |
Set to “10000” | Set to “01001” |
warning!
Do not turn the power off at the circuit breaker, then back on, for the previously installed Versa•Touch2 fan(s), as you may inadvertently change the frequency settings for it as well.
|
| 2 | |
| 3 | 1 | |
| Press in this order to set new | ||
Circuit Breaker |
| frequency: | |
1. High | 2. Med 3. Low | ||
or Fuse Box | |||
18
