Assembly
Mounting the Sliding Table Continued
3.Slide the hardware toward the cast mounting bracket located on the saw body. Place the adjusting plate on top of the set screws as shown (A,Fig.5).
4.Tighten the lock knob slightly, leaving loose for adjustment.
5.Repeat procedure for rear mounting bracket.
6.Adjusting the parallel of the saw table and sliding table with the four set screws (A, Fig.5).
Installing the Sliding Table Carriage
1.Locate the sliding table carriage mounting hardware as shown. Figure 6.
2.Slide the
3.Attach the carriage table support arm to the bottom the the sliding table carriage using two 8MM carriage bolts, two 8MM washers and two 8MM hex bolts. The head of the carriage bolts should lock into the bottom of the sliding table carriage. Finger tighten the two 6MM hex bolts only until next step is completed. Figure 8.
A
Figure 5
Figure 6
Figure 7
Figure 8
9