RedMax SGCZ2450S manual Fuel, Gasoline Requirements, OIL Requirements, Warranty

Page 10

SGCZ2450S

7. Fuel

FUEL

lines or fuel tank of the engine.

WARNING

•Gasoline is very flammable. Avoid smoking or bringing any flame or sparks near fuel. Make sure to stop the engine and allow it cool before refueling the unit. Select outdoor bare ground for fueling and move at least 10 ft (3 m) away from the fueling point before starting the engine.

■GASOLINE REQUIREMENTS

• All 2-Stroke RedMax Products are powered by RedMax Professional-Commercial Duty, Hi-Performance, Hi-RPM, Air Cooled 2-Stroke engines.

RedMax – Hi-Performance 2-stroke engines produce higher HP outputs as compared to standard Home Owner Duty or Light Commercial Duty production engines offered by most manufacturers.

• Exhaust emission are controlled by the fundamental engine parameters and components (eq., carburation, ignition timing and port timing) without addition of any major hardware or the introduction of an inert material during combustion.

• The RedMax Engines are registered and certified with CARB (California Air Resources Board) and EPA (Environmental Protection Agency) to operate on CLEAN Mid-grade 89 octane or Premium, unleaded (lead-free) gasoline and RedMax Air- Cooled "Max Life", Synthetic blend Premium two-stroke engine oil mixed at 50:1 ratio.

• Unleaded gasoline is recommended to reduce the contamination of the air for the sake of your health and the environment.

• This Hi-Performance Air Cooled 2-stroke Engine requires the

use of Minimum 89 Octane [ R+M ] (Mid grade or Premium) 2

clean gasoline. Gasoline may contain maximum of 10% Ethanol (grain alcohol) or up to 15% MTBE (Methyl tertiary-butyl ether). Gasoline containing Methanol (Wood Alcohol) is NOT approved.

NOTE

•IF octane rating of the Mid Grade gasoline in your area is lower than 89 Octane use Premium Unleaded Gasoline. The majority of all 2-stroke engine manufacturers in the USA and Canada recommend using gasoline with 89 Octane or higher.

WARNING

•Gasoline with an octane rating lower than 89 will greatly increase the engines operating temperature. Low octane gasoline will cause detonation (knock) resulting in piston seizures and major internal engine components damage.

•Poor quality gasolines or oils may damage sealing rings, fuel

US-10

NOTE

•Failures caused by operating engines on gasoline with octane rating lower than 89 are not covered by the RedMax Two- Stroke engine warranty.

WARNING

•Alternative Fuels (Not Gasoline)

Alternative fuels, such as E-15 (15% ethanol), E-20 (20% ethanol), E-85 (85% ethanol) are NOT classified as gasoline and are NOT approved for use in RedMax 2-stroke gasoline engines. Use of alternative fuels will cause major engine performance and durability problems such as: improper clutch engagements, overheating, vapor lock, power loss, lubrication deficiency, deterioration of fuel lines, gaskets and internal carburetor components, etc... Alternative fuels cause high moisture absorption into the fuel/oil mixture leading to oil and fuel separation.

■OIL REQUIREMENTS

•Use only RedMax "Max Life", Synthetic blend Premium Air- Cooled two-stroke engine oil or oil certified to ISO-L-EGD (ISO/CD1378) standard AND one that is JASO-FD registered. RedMax Air-Cooled "Max Life", Synthetic blend Premium two stroke engine oil and ISO-L-EGD (ISO/CD1378) AND JASO-FD oils are fully compatible with gasoline's containing 10% Ethanol. RedMax Air-Cooled "Max Life", Synthetic blend Premium two stroke engine oil and ISO-L-EGD (ISO/CD1378) AND JASO-FD oils are Universal and should be mixed at 50:1 ratio for all 2 stroke air cooled engines sold in the past regardless of mixing ratios specified in those manuals.

•If the oil is registered with JASO, the JASO Logo with FD and registration number will be displayed on the container. The highest JASO rating is "FD", which equals the ISO-L-EGD rating. Lower ratings are "FC", "FB", and "FA".

•Engine problems due to inadequate lubrication caused by failure to use ISO-L-EGD certified and JASO FD registered oil such as "MaxLife", RedMax Synthetic blend Premium 2-stroke oil WILL VOID THE REDMAX TWO-STROKE ENGINE

WARRANTY.

WARNING

•Do not use NMMA (National Marine Manufacturers Association), BIA (Boating Industry Association), and TCW (two cycle water cooled) oils designed for MoPeds or Outboard, water cooled Marine Engines. Do not use API (American Petroleum Institute), TC (Two Cycle) labeled oils. The API-TC

Page 9 Page 11
Image 10
Page 9 Page 11
Contents SGCZ2450S Contents Parts location SpecificationsSGCZ2450S Emission Control Symbols on the machineManufactured For safe operation Before use Using the productStarting the engine Transport Fuel safetyMaintenance StorageDisposal Set up Fuel WarrantyFuel Gasoline RequirementsFor Your Engine LIFE, Avoid HOW to MIX Fuel Recommended Mixing Ratio Gasoline 50 OILFueling the Unit Operation Cutting Work OP7 HOW to USEOP8 OP9 Recommended ApplicationsMA1 MA2 MaintenanceMaintenance Chart BladeMuffler Replacement Plug is a NGK CMR7H MA8MA4 AIR Filter MA5Storage Procedures to be Performed After Every 100 Hours of USEDisposal Case 1. Starting failure Troubleshooting guideCheck Probable Causes Action Warranty Commencement Date Manufacturers Warranty CoverageOwners Warranty Responsibilities What is CoveredHOW to File a Claim Emission Warranty Parts ListWhat is not Covered Where to GET Warranty Service

SGCZ2450S specifications

The RedMax SGCZ2450S is a powerful and efficient outdoor power equipment option primarily designed for landscape maintenance professionals and homeowners who require heavy-duty performance. This versatile machine primarily functions as a brush cutter, making it ideal for tackling dense brush, tall grass, and overgrown vegetation.

One of the standout features of the SGCZ2450S is its robust engine. It is equipped with a high-performance 24.5cc two-stroke engine that provides exceptional torque and power, allowing users to cut through tough terrain with ease. The engine's design incorporates advanced technologies to ensure lower emissions and improved fuel efficiency, aligning with contemporary environmental standards while delivering the necessary power for demanding tasks.

Another significant characteristic of the SGCZ2450S is its ergonomic design. The machine features a comfortable handle with soft grips, which minimizes vibrations during operation. This design choice reduces user fatigue, enabling longer work periods without discomfort. Additionally, the adjustable handle allows for personalized positioning, further enhancing user comfort and efficiency.

The RedMax SGCZ2450S also excels in versatility. The machine is equipped with a variety of attachments that allow it to perform multiple functions. Users can easily change from a brush cutting blade to a trimmer head, enabling seamless transitions between cutting paths and trimming tasks. This adaptability makes it an invaluable tool for landscapers and garden enthusiasts alike.

One notable technological feature is its Easy Start system, which simplifies the starting process. This system markedly reduces the effort required to start the engine, ensuring that users can get to work quickly without hassle. Furthermore, the machine’s air filter is designed for easy access and maintenance, promoting longevity and consistent performance.

In conclusion, the RedMax SGCZ2450S stands out due to its powerful engine, ergonomic design, and remarkable versatility. With advanced technologies that enhance performance and reduce user fatigue, it represents an excellent choice for anyone in need of a reliable and efficient brush cutter. Whether for extensive landscaping work or routine yard maintenance, the SGCZ2450S delivers quality results across various applications.
Top Page Image Contents