Hitachi 232133 manual Injection Hazard

Page 3

WARNING

INJECTION HAZARD

Spray from the gun, leaks or ruptured components can inject fluid into your body and cause extremely serious injury, including the need for amputation. Fluid splashed in the eyes or on the skin can also cause serious injury.

DFluid injected into the skin is a serious injury. The injury may look like just a cut, but it is a serious injury. Get immediate medical attention.

DDo not point the gun at anyone or at any part of the body.

DDo not put your hand or fingers over the spray tip.

DDo not stop or deflect leaks with your hand, body, glove or rag.

DDo not “blow back” fluid; this is not an air spray system.

DAlways have the tip guard and the trigger guard on the gun when spraying.

DCheck the gun diffuser operation weekly. Refer to the gun manual.

DBe sure the gun trigger safety operates before spraying.

DLock the gun trigger safety when you stop spraying.

DFollow the Pressure Relief Procedure on page 8 if the spray tip clogs and before cleaning, checking or servicing the equipment.

DTighten all fluid connections before operating the equipment.

DCheck the hoses, tubes, and couplings daily. Replace worn or damaged parts immediately. Do not repair high pressure couplings; you must replace the entire hose.

DFluid hoses must have spring guards on both ends, to help protect them from rupture caused by kinks or bends near the couplings.

TOXIC FLUID HAZARD

Hazardous fluid or toxic fumes can cause serious injury or death if splashed in the eyes or on the skin, inhaled, or swallowed.

DKnow the specific hazards of the fluid you are using.

DStore hazardous fluid in an approved container. Dispose of hazardous fluid according to all local, state and national guidelines.

DAlways wear protective eyewear, gloves, clothing and respirator as recommended by the fluid and solvent manufacturer.

308801 3

Image 3
Contents Read and Keep for Reference 308801Models 232133 and 232131, Series a Model 232132 and 232130, Series aSymbols Table of ContentsInjection Hazard Fire Skin Injection Explosion Hazard Fire and Explosion HazardDC a Component Function and IdentificationModel 232133 Shown SetupGrounding How to use the gun safety latchHow to use the pressure control How to use the pressure drain valveInjection Hazard Pressure Relief ProcedureHow to use the RAC IV tip guard How to remove a tip clogStartup Fire and Explosion Hazard Adjust spray patternShutdown and Care Relieve pressure When to flushHow to flush FlushingOpen or drain position Basic Problem Solving TroubleshootingElectrical Intermediate Problem Solving Replace pin if missing. Be sure retainer Unit will not run on generator but does run on AC power Fire Hazard General Repair InformationTool List Moving Parts HazardSetup Motor TestArmature Short Circuit Test Motor Brushes Test brushesElectric Shock Hazard Displacement Pump Repairing pumpRemoving pump See Motor Remove three drive housing screwsLED Sprayer Operation Indicates What to do Blinks Motor control board diagnosticsMotor Control Board Motor control board removalOn/Off Switch Power Supply CordDrive Housing, Connecting Rod, Crankshaft Not shown Removal InstallationPressure Transducer Pressure Transducer SealSuction Hose Models 232132 Replacement Drain ValveRepair Technical Data DimensionsAccessories Model 232132 and 232133, Series a Complete Sprayer PartsSee manual 51H 235014 ASSEMBLY, drain valve240519 CONNECTING, rod assy 239769 KIT, pump, displacementModel 232130 and 232131, Series a 236352 POTENTIOMETER, pressure adj 239979CRANKSHAFT, U-695 ManualToll Free Graco Standard WarrantyAdditional Warranty Coverage Phone Number