Hitachi 232133 manual Fire and Explosion Hazard, Fire Skin Injection Explosion Hazard

Page 4

WARNING

FIRE AND EXPLOSION HAZARD

Improper grounding, poor ventilation, open flames or sparks can cause a hazardous condition and result in a fire or explosion and serious injury.

DIf there is any static sparking or you feel an electric shock while using this equipment, stop spray- ing immediately. Do not use the equipment until you identify and correct the problem.

DProvide fresh air ventilation to avoid the buildup of flammable fumes from solvents or the fluid being sprayed.

DKeep the spray area free of debris, including solvent, rags, and gasoline.

DElectrically disconnect all equipment in the spray area.

DExtinguish all open flames or pilot lights in the spray area.

DDo not smoke in the spray area.

DDo not turn on or off any light switch in the spray area while operating or if fumes are present.

DDo not operate a gasoline engine in the spray area.

DUse only with a grounded outlet that matches the grounded plug of this equipment.

MOVING PARTS HAZARD

Moving parts can pinch or amputate your fingers.

DKeep clear of all moving parts when starting or operating the pump.

DBefore servicing the equipment, follow the Pressure Relief Procedure on page 8 to prevent the equipment from starting unexpectedly.

NOTE: This is an example of the DANGER label on your sprayer. This label is available in other languages, free of charge. See page 31 to order.

FIRE AND

SKIN INJECTION

EXPLOSION HAZARD

HAZARD

Spray painting, flushing or cleaning equipment with flammable liquids in

Liquids can be injected into the body by high pressure airless spray or

confined areas can result in fire or explosion.

leaks – especially hose leaks.

Use outdoors or in extremely well ventilated areas. Ground equipment,

Keep body clear of the nozzle. Never stop leaks with any part of the

hoses, containers and objects being sprayed.

body. Drain all pressure before removing parts.Avoid accidental trigger-

Avoid all ignition sources such as static electricity from plastic drop

ing of gun by always setting safety latch when not spraying.

 

cloths, open flames such as pilot lights, hot objects such as cigarettes,

Never spray without a tip guard.

arcs from connecting or disconnecting power cords or turning light

In case of accidental skin injection, seek immediate

switches on and off.

“Surgical Treatment”.

Failure to follow this warning can result in death or serious injury.

Failure to follow this warning can result in amputation or serious injury.

 

READ AND UNDERSTAND ALL LABELS AND INSTRUCTION MANUALS BEFORE USE

4308801

Image 4
Contents 308801 Models 232133 and 232131, Series aModel 232132 and 232130, Series a Read and Keep for ReferenceTable of Contents SymbolsInjection Hazard Fire and Explosion Hazard Fire Skin Injection Explosion HazardComponent Function and Identification DC aSetup Model 232133 ShownHow to use the gun safety latch How to use the pressure controlHow to use the pressure drain valve GroundingPressure Relief Procedure How to use the RAC IV tip guardHow to remove a tip clog Injection HazardStartup Adjust spray pattern Fire and Explosion HazardShutdown and Care When to flush How to flushFlushing Relieve pressureOpen or drain position Troubleshooting Basic Problem SolvingElectrical Intermediate Problem Solving Replace pin if missing. Be sure retainer Unit will not run on generator but does run on AC power General Repair Information Tool ListMoving Parts Hazard Fire HazardMotor Test SetupArmature Short Circuit Test Test brushes Motor BrushesElectric Shock Hazard Repairing pump Displacement PumpRemoving pump See Remove three drive housing screws MotorMotor control board diagnostics Motor Control BoardMotor control board removal LED Sprayer Operation Indicates What to do BlinksPower Supply Cord On/Off SwitchDrive Housing, Connecting Rod, Crankshaft Not shown Installation Pressure TransducerPressure Transducer Seal RemovalSuction Hose Models 232132 Drain Valve ReplacementRepair Dimensions Technical DataAccessories Complete Sprayer Parts Model 232132 and 232133, Series a51H 235014 ASSEMBLY, drain valve 240519 CONNECTING, rod assy239769 KIT, pump, displacement See manualModel 232130 and 232131, Series a 239979 CRANKSHAFT, U-695Manual 236352 POTENTIOMETER, pressure adjGraco Standard Warranty Additional Warranty CoveragePhone Number Toll Free