Hitachi 308640 manual 14a

Page 20

Parts

Part No. 238851 and 239001

13

11

24

23

10

18

315

14a

14

25

10b

10a

17

430

29

5

5a

5b

8 1

7

6

26

19

9

3	2	34

2 1

SERVICE NOTES (See Fig. 8 for additional information):

1Apply high strength sealant to threads.

2Torque to 23±27 ft-lb (31±37 NSm)

3Gasket (18) must be replaced if diffuser-seat (15) is removed or replaced to avoid fluid leakage.

4

Gasket (17) must be replaced if fluid connector (30) is removed or replaced to avoid fluid leakage.

06759B

20 308640

Image 20

Contents 308640 Part No , Series aPart No , Series B This manual contains important warnings and informationTable of Contents Equipment Misuse Hazard Installation Typical InstallationVentilate the Spray Booth T QConnect the Air Line Connect the Fluid LineObject being sprayed Ground it according to local code Ground the SystemFluid supply container Ground it according to local code Operation SafetyPressure Relief Procedure Install a Spray Tip How the Air-Assisted Spray Gun OperatesSelect a Spray Tip and Air Cap Your applicationAdjust the Spray Pattern Recoil HazardApply the Fluid Clean the Spray Gun and System Daily Check the Diffuser-seat Operation WeeklyFlush the Gun Daily 308640 Troubleshooting General TroubleshootingProblem SolutionSpray Pattern Troubleshooting Fluid Needle Cartridge Service ServiceAir Valve Service AIR Service Notes 10b 10aParts Part No , 238852, 238883,Description Qty 35Y 172479 TAG, instruction not shown Repair KitsDescription Qty 14a 10b 111517 RING, backup Ptfe r 238701 238755 NEEDLE, fluid, hi-flow Included with192096 239172Spray Tip Selection Charts Standard Spray Tips, for use with Air CapFluid output at 600 psi 4.1 MPa, 41 bar On the next 238402 238851 238852 238883 239001 241070 DimensionsMeasurements, inches mm Gun Technical Data Sound DataAccessories Graco Standard Warranty Graco Phone NumberManual Change Summary Manual changed per ECO