Fan Belt
Removal | Installation |
1.Fig. 3. Remove two screws (141) and slide shroud (23) up and off of sprayer.
2.Loosen four fasteners on underside of engine (1).
3.Loosen belt tension adjustment screw.
4.Slide engine to left (rear view) to remove tension on belt.
1.Thread new belt around bottom drive pulley, and install on fan pulley.
a.lightly snug four engine fasteners.
b.Loosen jam nut on belt tension adjustment screw and slowly tighten screw. (This adjusts belt tension.) Tighten jam nut after belt is properly adjusted.
2.Adjust belt tension to be able to twist belt about 45_.
3.Align engine flush to front of alignment lip. Tighten four fasteners at base of engine.
5.Remove belt (6). 141
23 
1
4. Install fan shroud (23) with two screws (141).
6
45_
Twist
Engine
Alignment
Flange
A
A
Belt Tension
Adjustment Screw
View A – A
95
Fig. 3 | ti1475a |