Graco 3A0149E important safety instructions Reverse-A-CleanRAC Tip, Engaged

Daily Gun Care, Flushing, and Cleaning

TI6570A

FIG. 23

13.If the diffuser was removed, trigger the gun while you reinstall the diffuser (5) with the gun tool (30). Tighten the diffuser securely to obtain a good seal. Torque to 155-165 in-lb (18-19 N•m). When properly tightened, the flange will bottom out on the gun.

14.Install the air cap retaining ring (6), air cap (21), and spray tip (33).

TI6568A

FIG. 24

15.Dampen a soft cloth with solvent and wring-out the excess. Point the gun down and wipe off the outside of the gun.

TI6571A

FIG. 25

16.After cleaning the gun, lubricate the following parts with lubricant 111265 weekly:

•Trigger pivot pin (A)

•Boss on both sides of the gun where the trigger contacts the gun body (B)

•Fluid needle shaft, behind trigger (C)

AB

C

TI6553A

FIG. 26

Reverse-A-Clean®(RAC) Tip

NOTE: Do not soak the RAC tip seat gasket (33a) in sol- vent for extended periods of time or swelling may occur.

Clearing a clogged RAC tip

Release the trigger and engage the trigger lock.

TI6581A

ENGAGED

FIG. 27

16 3A0149E