Setup
7. Actuate gun to check for full mix chamber travel.
Front of air cap (C) should be approximately flush with front retaining ring (U).
U
C 
TI4766a
8. Open cleanoff air valve (K)
actuate air line to check that cleanoff air is flowing. Adjust as desired.
K
11. Open B (RESIN) fluid valve (about three half
turns). Then open A (ISO) fluid valve.
TI4752A
12. Disengage piston safety lock.
TI3849
13. Test spray onto card board. Adjust pressure and
9. Engage piston safety lock.
temperature to get desired results.
TI2409A
10. Turn on proportioner.
TI4763A
14. Apply layer of lubricant over front of gun and
lock ring, or use gun cover to prevent overspray buildup and ease disassembly. See Fusion Gun Manual 309856 or 309550 to order lubricant and gun cover
15. Gun is ready to spray.
CAUTION
Air supply is required for gun actuation. Do not dis- connect gun air supply until fluid pressure is relieved, see page 13.
12 | 310649C |