Startup
Startup
1. Turn pressure control to lowest pressure.
5.Hold gun against grounded metal flushing pail. Trig- ger gun and increase fluid pressure 1/2 turn. Flush 1 minute.
1/2
ti4271a
ti13243a
2. Turn power ON.
ti4266a
ti4266a
3.Increase pressure 1/2 turn to start motor and allow fluid to circulate through drain tube for 15 seconds; turn pressure down.
15sec.
6.Inspect for leaks. Do not stop leaks with hand or a rag! If leaks occur, perform Pressure Relief Proce- dure, page 8. Tighten fittings. Perform Startup, steps 1 - 5. If no leaks, proceed to step 7.
7.Place pump in paint pail.
ti2714a
PAINT
8.Trigger gun again into flushing pail until paint appears. Move gun to paint pail and trigger for 20 seconds. Set gun safety ON. Assemble tip and guard, see instructions on next page.
1/2
4. Turn prime valve forward to SPRAY position. Disen- gage gun trigger safety.
ti10166a
ti13029a
ti14845a | ti10167a |
10 | 3A0156A |