Code Number Models | Graco Inc 695 Premium Hi, 795 Premium Hi

Secondary Menu - Stored Data and WatchDog Pump Protection Modes

1.Perform Pressure Relief, steps 1 - 4 if they have not already been done.

2.Turn power switch on while holding DTS button down.

ti4266a

ti13605a

3.SERIAL NUMBER scrolls past and then serial num- ber (e.g. 00001) displays.

ti13622a

ti7362a

4.Short press DTS button and MOTOR HOURS scrolls past and then total motor run hours are dis- played.

Digital Tracking System (Not Available on All Units)

7.Short press DTS button. W-DOGscrolls past then OFF displays if watchdog switch is OFF. ON dis- plays if Watchdog switch is ON.

ti13608a

ti13626a

ti13614a

8.Press and hold (8 seconds) DTS button to move to WatchDog Trigger % menu. Continue to hold DTS button and Watchdog can be set to trigger at 30, 40, 50, or 60% of current sprayer pressure setting. Release DTS button when desired % is displayed. Default is 50%.

ti13618a

ti13619a

5.Short press DTS button. LAST ERROR CODE scrolls by and last error code is displayed; e.g. E=07 (see Repair manual).

ti13601a	ti13615a

ti13607a

6.Press and hold DTS button to clear error code to zero.

ti13609a

ti13606a

TIA

9. Short press to move to SOFTWARE REV.

ti13613a

ti13623a

10.Short press DTS button. MOTOR ID RESISTOR scrolls by and model code number (see below).

Code Number	Models

0	695

2	795 / MARK IV

4	1095 / 220V MARK V

6	1595 / 120V MARK V

3A0156A