Graco Inc 307010L, 208008 Operation, Skin Injection Hazard, Procedure on page

Operation

WARNING

SKIN INJECTION HAZARD

To reduce the risk of serious injury, whenever you are instructed to relieve pressure, follow the Pressure Relief

Procedure on page 4.

Whenever you stop spraying for a moment, en- gage the gun safety latch. See Fig. 2.

Safety Off

WARNING

The wallet-sized warning card provided with this gun should be kept with the operator at all times. The card contains important treatment informa- tion should an injection injury occur. Additional cards are available at no charge from Graco Inc.

1.Start the pump. Adjust the fluid pressure so the spray is completely atomized. Always use the lowest pressure necessary to get the desired results. Higher pressure may not improve the spray pattern and will cause premature tip and pump wear.

2.If adjusting the pressure does not give a good spray pattern, try another tip size. Be sure to relive pressure completely before changing tips.

3.Use a full-open, full-close trigger action. Hold the gun about 14 in. (350 mm) from and at right angles to the work surface. Do not swing the gun in an arc. Practice to find the best length and speed of stroke.

Safety On

8122

Fig. 2

6 307010