ALWAYS
þALWAYS follow H.E.R.O. recommendations for operation and safety completely.
þALWAYS ensure that switch is in off position before plugging in the electric motor.
þALWAYS set trigger lock on gun in "LOCKED" position when not in use, with gun locked close.
þALWAYS check connections and fittings for tightness before operating the unit.
þALWAYS locate the unit in a well ventilated area a minimum of 25 feet from the spray area.
þALWAYS ground the unit, the paint containers, and the object being sprayed to eliminate static discharge. Ensure that all these objects remain grounded throughout the entire spraying operation.
þALWAYS use approved 3 prong grounded extension cord and approved grounded outlets of the voltage and frequency specified on the motor. The outlet must be at least 25 feet from the spraying area.
þALWAYS use approved 3 prong grounded extension cord not less than # 12/3 gauge up to 50 feet, and not less than # 10/3 gauge up to 100 feet. DO NOT exceed 100 feet of extension cord.
þALWAYS use accessories and components approved for at least 3000 psi (working pressure) in the spraying system.
þALWAYS use accessories and components supplied by H.E.R.O. Industries Ltd., or specifically approved in writing by H.E.R.O. Industries Ltd. on with the unit.
þALWAYS examine accessories for wear or damage before operating the unit.
þALWAYS use lowest possible pressure when flushing and cleaning the unit, and hold the gun firmly against a metal container to reduce static discharge possibility.
þALWAYS wear a face filter mask when operating the unit.
þALWAYS ;
1.Turn off the motor.
2.Disconnect the power cord from the outlet.
3.Relieve all pressure in the pump by triggering the gun.
4.Lock gun trigger in "LOCKED" position, with gun locked closed before attempting to perform any maintenance or service on any part of the unit spray system.
þALWAYS wear safety glasses when operating the unit.
þALWAYS ensure fire extinguishing equipment is readily available and properly maintained in the spray area.
þALWAYS observe good housekeeping and keep the spray area free from obstructions.
þALWAYS be aware that certain chemicals may react with aluminum, carbide, or other components in the pump system. Read the manufacturer's label on all materials to be sprayed, and follow the manufacturer's recommendations. If in doubt, consult your material supplier to be sure.
þALWAYS replace any damaged airless paint hose. A scratched, torn, cut or otherwise damaged outer core of the paint hose can lead to a rupture. DO NOT attempt to repair a damaged hose.
H.E.R.O. INDUSTRIES LTD. | 4 | 1100MD OWNERS MANUAL - “B” VERSION |