Campbell Hausfeld AL2710 Troubleshooting Chart, Symptom Possible Causes Corrective Action

Page 14

Operating Instructions and Parts Manual

AL2710

Airless Paint Systems

Troubleshooting Chart

 

 

Symptom

Possible Cause(s)

Corrective Action

 

 

 

 

 

 

 

 

 

 

 

Unit does not prime

1.

Air leak due to:

 

 

 

 

 

 

 

a. Loose suction nut.

 

a. Tighten suction nut.

 

 

 

 

 

b. Worn O-rings.

 

b. Replace O-ring (PN 106-011) on suction seat.

 

 

 

 

 

c. Hole in suction hose.

 

c. Replace suction hose.

 

 

 

 

2.

Stuck or faulty balls.

1.

Service lower and upper check valves.

 

 

 

 

 

 

 

 

 

 

 

Unit primes, but has no

1.

Pressure set too low.

1.

Turn up pressure.

 

 

 

pressure or poor pressure

2.

Filters are clogged.

2.

Clean or replace gun filter, inlet filter and/or manifold

 

 

 

 

 

 

filter.

 

 

 

 

3.

Upper check valve faulty or

3.

Service upper check valve.

 

 

 

 

worn.

 

 

 

 

 

 

4.

Prime/Pressure Relief Valve

4.

Clean or replace Prime/Pressure Relief Valve.

 

 

 

 

bypassing.

 

 

 

 

 

 

5.

Packings and/or piston worn.

5a. Tighten packing nut.

 

 

 

 

 

 

b. Repack unit.

 

 

 

 

 

 

 

 

 

 

 

Unit does not maintain

1.

Blown spray tip.

1.

Replace spray tip.

 

 

 

good spraying pressure

2.

Packings and/or piston worn.

2.

Repack unit.

 

 

 

 

3.

Upper seat worn.

3.

Replace upper seat.

 

 

 

 

 

 

 

 

 

 

 

Unit does not run

1.

Blown fuse.

1.

Replace fuse (20A SlowBlow).

 

 

 

 

2.

Electrical failure.

2.

See electrical troubleshooting on page 15.

 

www.chpower.com

14

Page 13 Page 15
Image 14
Page 13 Page 15
Contents AL2710 Operating Instructions and Parts ManualSafety Guidelines Table of ContentsSpecifications General Safety InformationElectrical Shock Hazard Skin Injection HazardFlushing Pre-OperationFire or Explosion Hazard Amperage Length of Cord Ft RatingSetting UP HOW to FlushProcedure Important ComponentsSpray TIP Selection OperationStarting UP Tip Selection Chart Electrical Board Calibration Electrical SystemSpray Technique Zero CalibrationLiquid Crystal Display LCD Calibration Electrical TroubleshootingPressure Calibration Spray GUN ServiceReplacement of Electrical Components Replacing Valve Spring Unit Fluid Pump ReinstallationGear and Pump Assembly Fluid PumpMaintenance Reassembly Troubleshooting Chart Symptom Possible Causes Corrective ActionElectrical Troubleshooting Possible Cause Corrective ActionFor Replacement Parts, Call AL2710 Spray GunParts List for Spray Gun for use with AL2710 AL2710 Spray Gun Ref. No Description Part Number QtyAirless Paint Sprayer Model AL2710 Parts List for Airless Paint Sprayer, Model AL2710 Not applicableElectrical System Parts List for Electrical System Ref. No Description Part Number QtyAL2710 Manifold Filter Parts List for Manifold Filter 111-200-99 Ref. No Description Part Number QtyParts List for Piston Rod, Upper Check Valve Piston Rod and Upper Check ValveLower Suction Valve Parts List for Lower Suction Valve Gear and Pump Assembly Parts List for Gear and Pump Assembly Parts List for Fluid Pump 331-236 Ref. No Description Part Number QtyWhat is not Covered Under this Warranty Responsibilities of Purchaser Under this Warranty

AL2710 specifications

The Campbell Hausfeld AL2710 is a versatile and efficient air compressor, designed to meet the demands of both DIY enthusiasts and professional users. With a compact design and a range of powerful features, this compressor stands out in its category for its reliability and performance.

One of the key features of the AL2710 is its 1.5 HP motor, which provides consistent and powerful airflow. It operates at a maximum pressure of 125 PSI, making it suitable for a variety of applications, from inflating tires and powering air tools to providing air assistance for painting and finishing tasks. The compressor has a tank capacity of 3.5 gallons, enabling it to store enough air for extended use without frequent cycling.

The AL2710 is built with portability in mind. Weighing just over 40 pounds, it comes with an ergonomic handle and a lightweight design that allows for easy transportation to various job sites. Its low-profile design not only enhances mobility but also makes it easy to store in tight spaces.

Another notable characteristic is its oil-free pump, which significantly reduces maintenance requirements. This technology not only contributes to a cleaner operation but also enhances the compressor's lifespan. Users can benefit from the convenience of not needing to deal with oil changes, allowing them to focus more on their work.

The unit features a quick-connect coupler for rapid tool changes, enhancing productivity. Additionally, the integrated pressure gauge enables users to monitor air pressure levels with ease, ensuring optimal performance of their air-powered tools.

Noise levels are also a consideration for many users. The Campbell Hausfeld AL2710 operates at a relatively low noise level, making it suitable for use in residential areas or noise-sensitive environments.

In summary, the Campbell Hausfeld AL2710 air compressor is defined by its powerful and portable design, oil-free operation, and user-friendly features. It is an ideal choice for those who need a reliable compressor for various tasks, combining efficiency, durability, and ease of use. Whether for home improvement projects or professional applications, the AL2710 provides the necessary performance to get the job done effectively.
Top Page Image Contents