Campbell Hausfeld AL2710 operating instructions Electrical Shock Hazard, Skin Injection Hazard

Operating Instructions and Parts Manual AL2710

Airless Paint Systems

General Safety Information (Cont.)

4.Do not smoke or eat when spraying paint, insecticides, or other flammable substances.

5.Always work in a clean environment. To avoid injury and damage to the workpiece, do not aim the spray gun at any dust or debris.

6.When spraying and cleaning, always follow the instructions and safety precautions provided by the material manufacturer (Refer to MSDS).

!DANGER

ELECTRICAL SHOCK HAZARD:

●Follow all local electrical and safety codes, as well as the National Electrical Code (NEC) and in the United States, the Occupational Safety and Health Act (OSHA).

●This product requires a grounded 120V, 15 Amp circuit (See Figure 1).

Grounded

Outlet

Grounding Pin	Grounded Outlet
Figure 1 - Grounding	Box

●If the power receptacles available will not fit this equipment’s power cord, then have an appropriate power receptacle installed by a certified electrician.

●Only qualified electricians or service personnel should perform maintenance on the electrical components of this equipment.

●If using an extension cord, use only grounded three wire extension cords

that are in good condition. See Table 1 on page 4 for information on proper extension cord gauges.

●Do not modify any of the electrical components of this equipment.

●Do not use a power cord adapter with this equipment.

●Check with a qualified electrician or service person if the grounding instructions are not completely understood or you are in doubt as to whether the equipment is properly grounded.

!WARNING

SKIN INJECTION HAZARD:

●High pressure spray can inject toxins into blood stream. If injection occurs,

seek emergency medical treatment.

! WARNING

Use a face mask/respirator and protective clothing

when spraying. Always spray in a well ventilated area to prevent health and fire hazards. Refer to Material Safety Data Sheets (MSDS) of spray material for details.

●Never try to stop leaks with any part of your body.

●This system is capable of producing 3000 psi. Use only Campbell Hausfeld replacement parts rated at 3000 psi or higher.

●Never spray without tip guard.

●Ensure trigger lock is functioning properly.

●Always engage trigger lock when not spraying.

●Do not remove spray tip while cleaning pump.

●Never leave equipment pressurized while unattended.

PRESSURE RELIEF PROCEDURE

Before servicing or resting unit, relieve pressure from system by following this procedure:

1.Engage gun trigger lock.

2.Turn unit off and disconnect power.

3.Disengage gun trigger lock.

4.Trigger gun into grounded pail to relieve pressure in hose and

gun. While doing so, hold metal part of gun in contact with pail. Use the smallest amount of pressure possible.

5.Turn

Prime/Pressure Relief Valve

(PR Valve) to Wide Gap

the open (priming) position to

relieve Slight Gap

pressure.

NOTE: There will be a wider gap between valve handle and cam body when in open position.

6.Engage gun trigger lock. Close Prime/Pressure Relief Valve.

NOTE: If spray tip or hose is clogged, follow step 1 to 5. If you suspect pressure has not been relieved after following this procedure, take your unit to a Campbell Hausfeld Service Center.

●Do not clean spray tip while it is attached to the spray gun. Remove spray tip from gun to clean tip guard.

●Ensure tightness of high pressure connections.

www.chpower.com

3