Grizzly G3358 owner manual LubricationV-Belts, Points requiring periodic lubrication are

Page 31

LubricationV-Belts

Points requiring periodic lubrication are:

The main column. A light film of oil (SAE

30)will smooth action and prevent rust and corrosion.

The quill. A light coating of oil (SAE 30) will ensure smooth movement.

The quill pinion. Lubricate every 90 days with non-hardening grease.

The table leadscrews. Lubricate once each week with several drops of SAE 30.

Ball Oilers. Wipe the outer surface of the ball fitting with a clean cloth to remove con- taminants. Press the ball of the fitting with the tip of the oiler. Press a few drops of oil into the ball fitting, then clean up any residue with a cloth (Figure 39).

Ways. Periodically lubricate the ways with Moly-D way oil.

Figure 39. Ball oiler locations.

G3358 Milling/Drilling Machine

Inspect regularly for tension and wear. Refer to Figure 40 for proper belt tension. Belt deflection should be approximately 1/4" under moderate pressure. Replace when necessary with a size B-42 belt for the spindle pulley to the idler pulley belt and a size B-34 belt from the idler pulley to the motor pulley belt. Check pulleys to ensure that they are properly aligned.

EjaaZn

9Z[aZXi^dc

EjaaZn

Figure 40. Belt tension.

-29-

Image 31
Contents Model G3358 Ss ,EAD from Leadbased PAINTS Table of Contents Foreword Functional Overview IntroductionContact Info Identification Machine Data Sheet Lead Screw Info Features  !,7!93 53%3 %!2.2 02/4%#4/ %. /0%2!4.! -!#.%29 #4/..3!&%493AFETYYNSTRUCTIONSSFORR-ACHINERY Machine Care and Maintenance Additional Safety for Mills110/220V Operation Circuit RequirementsDescription Qty SetupSetup Safety Unpacking Items Needed for SetupCrate Contents Figure Qty Inventory Clean UpWorkbench Load Placement LocationSite Considerations Moving & Placing MachineHandwheels MountingAssemblyTo mount the handwheels to the machine Hardware Recognition Chart Column Cap Head CrankFeed Levers Face Mill To install the drill chuckTo install the face mill Drill Chuck ArborTo test run the machine Test Run & BreakTo break-in the spindle Operations Operation Safety Basic ControlsTable travel controls Head Crank Collet/Arbor To install a collet or an arborTo remove a collet or an arbor Spindle Height To operate the micro-adjustment handwheelTo lock the spindle To calibrate the depth stop Depth StopTo change spindle speeds Speed ChangesPosition Cutting Speeds for High Speed Steel HSS Cutting Tools Graduated DialsExample G1076-52-PC. Clamping Kit AccessoriesH2689-R-8 Quick Change Collet Set G9299-10 Yuasa-Type Rotary TableG5641-1-2-3 Blocks G9815-Parallel Set H5556-Edge Finder Set G2861-Face Mill G4051-Carbide Insert for Face MillG9765-9-PC. Ball End Mill Set Daily Check MaintenanceCleaning Protecting SchedulePoints requiring periodic lubrication are LubricationV-BeltsTroubleshooting ServiceMotor & Electrical Fan Operation and Work Results Return Spring To adjust the spring tensionQuill Gibs To adjust the Y-axis leadscrewElectrical Safety Instructions WiringSwitch Both Sides Shown Wiring DiagramMain Parts Breakdown Series PartsDescription Main Parts ListColumn Gear Cover Base Parts Breakdown Series Base Parts List Label Breakdown and List 22!.49 #!2$ 99.$5342!, .# 0//88 %,,.!- 7!  Warranty and Returns #ALL 4ODAYD&ORO! &2%%