Specifications Table, Save this Manual | Harbor Freight Tools 47158

SPECIFICATIONS TABLE

Electrical Requirements	120 V / 6 0 Hz / 1/5 HP
2 Speed Ranges	High: 100-2,000 RPM / Low: 100-1,000 RPM
Maximum Chuck Capacity	25/64” Drill Bit / 25/64” End Mill / 3/4” Face Mill
Maximum X Travel	9”
Maximum Y Travel	4”
Maximum Z Travel	8-1/2”
X, Y, Z Graduations	.001” / Line
Table Size	9-3/8” x 5-3/8”
Table Slot	5/16” x 5/8”
Throat Depth	5-1/2”
Swing Diameter	11”
Base Size	10-1/8” x 9-3/8”
Spindle Stroke	1-3/16”
Spindle Taper	MT2
Weight	103 Pounds

SAVE THIS MANUAL

You will need this manual for the safety warnings and precautions, assembly, op- erating, inspection, maintenance and cleaning procedures, parts list and assembly diagram. Keep your invoice with this manual. Write the invoice number on the inside of the front cover. Keep this manual and invoice in a safe and dry place for future reference.

GENERAL SAFETY WARNINGS AND PRECAUTIONS

1.KEEP WORK AREA CLEAN AND DRY. Cluttered, damp, or wet work areas invite injuries.

2.KEEP CHILDREN AWAY FROM WORK AREA. Do not allow children to handle this product.

3.STORE IDLE EQUIPMENT. When not in use, tools and equipment should be stored in a dry location to inhibit rust. Always lock up tools and equipment, and keep out of reach of children.

4.DO NOT USE THIS PRODUCT IF UNDER THE INFLUENCE OF ALCOHOL OR DRUGS. Read warning labels on prescriptions to determine if your judgement or reflexes are impaired while taking drugs. If there is any doubt, do not attempt to use this product.

SKU 47158

For technical questions, please call 1-800-444-3353.

Page