5.Then, secure the Micro Mill/Drill Machine to the workbench, using the four 3/8” diameter bolts of appropriate length, four lock washers, and four nuts as mentioned in Step #2.
MACHINE ADJUSTMENT INSTRUCTIONS
NOTE: For additional references to the parts listed below, refer to the Assembly
Diagram on page 14.
To Use The Adjustment Controls:
1.CAUTION: ALWAYS TURN OFF THE MICRO MILL/DRILL MACHINE, UNPLUG ITS ELECTRICAL POWER CORD/PLUG (part #128), AND WAIT UNTIL IT COMPLETELY STOPS RUNNING BEFORE MAKING ANY ADJUSTMENTS.
2.To adjust the height of the Spindle Box (part #24) to accommodate the work- piece being milled/drilled; turn the Lifting Hand Wheel (part #97) clockwise to raise the Spindle Box, and turn the Lifting Hand Wheel counterclockwise to lower the Spindle Box. (See Figure B, and Assy. Diagram.)
3.To lower and raise the Chuck (part #132); pull the Handle Shaft (part #87) down to lower the Chuck. Pull the Handle Shaft up to raise the Chuck.
(See Figure B, and Assy. Diagram.)
4.To adjust the fine feeding mechanism; push in on the Clutch Lever (part #65) which is located on the Fine Feeding Hand Wheel (part #97). Turn the Fine Feeding Hand Wheel clockwise to bring the tip of the Chuck (part #132) up. Turn the Fine Feeding Hand Wheel counterclockwise to bring the tip of the Chuck down. The Fine Feeding Hand Wheel may be adjusted from 0” to
5.To move the Worktable (part #105)to the front and to the back; turn the Longitudinal Feed Hand Wheel (part #97) clockwise to position the Worktable toward the front of the machine. Turn the Longitudinal Feed Hand Wheel counterclockwise to position the Worktable toward the back of the machine. (See
Figure B, and Assy. Diagram.)
6.To move the Worktable (part #105) to the right and to the left; turn the Cross Feed Hand Wheel (part #97) clockwise to position the Worktable to the right. Turn the Cross Feed Hand Wheel counterclockwise to position the Worktable to the left. (See Figure B, and Assy. Diagram.)
SKU 47158 | For technical questions, please call | Page |