Harbor Freight Tools 47158 operating instructions Figure B

2.NOTE: When mounting the Micro Mill/Drill Machine on a workbench, you will need four 3/8” diameter bolts of appropriate length, four lock washers, and four nuts (not provided).

LIFTING HAND WHEEL	LIFTING HAND WHEEL
(#97)	(#97)

SPINDLE
BOX							HANDLE
(#24)		HIGH/LOW SPEED KNOB
							SHAFT
	(#124)
					(#87)
			CLUTCH LEVER
FORWARD		CLUTCH		(#65)
		LEVER (#65)
OFF
			FINE FEEDING				SPINDLE
REVERSE
									BOX
SWITCH		HAND WHEEL (#97)
					(#24)
(#125)				FINE FEEDING
				HAND WHEEL
			HANDLE SHAFT	(#97)
VARIABLE	(#87)
SPEED			CHUCK (#132)
KNOB (#122)
							CHUCK
								(#132)
WORK			LONGITUDINAL FEED
			HAND WHEEL
TABLE	(#97)
(#105)								WORK
								TABLE
						(#105)

CROSS FEED	LONGITUDINAL FEED
HAND WHEEL (#97)	HAND WHEEL (#97)

FIGURE B

3.With assistance, position the Micro Mill/Drill Machine in the desired location on the top of the workbench. Use the four mounting holes in the Base (part #74) of the Micro Mill/Drill Machine as a template, and trace with a pencil on the top of the workbench four 3/8” diameter mounting holes . Then, temporarily remove the Micro Mill/Drill Machine from the workbench. (See Assy. Diagram.)

4.Where the four pencil marks are located, drill four 3/8” diameter holes completely through the top of the workbench.

SKU 47158 For technical questions, please call 1-800-444-3353. Page