7.To turn the machine on/off, and adjust the rotational direction of the Chuck (part #132); turn the Switch (part #125) from its “OFF” position to its “FORWARD” position to turn on the machine and for a clockwise rotation of the Chuck. Turn the Switch from its “OFF” position to its “REVERSE” position to turn on the ma- chine and for a counterclockwise rotation of the Chuck. To turn off the machine, turn the Switch to its “OFF” position.
(See Figure B, and Assy. Diagram.)
8.To adjust the speed at which the Chuck (part #132) rotates; First set the High/Low Knob (part #124) until the letter “L” appears on its dial so that the Mirco Mill/Drill Machine begins running at its low speed range
OPERATING INSTRUCTIONS
NOTE: For additional references to the parts listed below, refer to the Assembly
Diagram on page 14.
1.CAUTION: Make sure the Switch (part #125) on the Micro Mill/Drill Machine is in its “OFF” position. Then, plug the Power Cord/Plug (part #128) into the nearest 120 volt, grounded,
2.Check to make sure the Handle Shaft (part #87) is in its full “UP” position.
(See Figure B, and Assy. Diagram.)
3.Place the workpiece on the Worktable (part #105) and, if possible, firmly secure the workpiece to the Worktable with clamps (not provided).
(See Figure B, and Assy. Diagram.)
4.Insert the shank of the drill bit/cutting tool (not provided) all the way up into the Chuck (part #132). Then, use the Chuck Key to tighten the Chuck onto the drill bit/cutting tool. NOTE: There are three tightening/loosening holes in the Chuck. Make sure to use the Chuck Key in all three holes.
(See Figures B, and C.)
REV 08/03
SKU 47158 | For technical questions, please call | Page |